Scientific Paper
Chitosan/Sn@C composite nanofiber coatings for QCM-based humidity sensing
Abstract
SnCl₂·2H₂O was introduced into polyacrylonitrile (PAN) nanofibers through a simple electrospinning method, and composite Sn nanoparticle–carbonized (Sn@C) nanofibers were prepared by two-stage calcination. After dispersing different amounts of composite nanofibers in a 2.5 wt% chitosan (CS) solution via ultrasonication, a series of CS/Sn@C composite humidity-sensitive layers were spin-coated on quartz crystal microbalance (QCM) sensor surfaces. The morphology, structure, and composition of Sn@C nanofibers were characterized by scanning electron microscopy (SEM), transmission electron microscopy (TEM), X-ray photoelectron spectroscopy (XPS), and nitrogen adsorption–desorption isotherm analysis combined with the Brunauer–Emmett–Teller (BET) method. The diameter of Sn@C nanofibers decreased from 180 nm to 95 nm upon decreasing the PAN content from 90% to 60%. The presence of metallic Sn nanoparticles, formed on the surface of Sn@C nanofibers, resulted in an increase in specific surface area from 5.1 m²·g⁻¹ to 106.5 m²·g⁻¹ . Using an electrospinning solution with PAN:SnCl₂·2H₂O (8:2 w/w) and a Sn@C dispersion (0.05 mg/mL) in 2.5 wt% CS solution, a QCM sensor with a fitting correlation coefficient of 0.9998 was fabricated. The sensor parameters were optimized through QCM testing under varying conditions. The sensor demonstrated fast response/recovery times: < 1.2 s (response)/50 s (recovery) in 11–33% RH and 67 s/37 s in 11–98% RH. Additionally, the CS/Sn@C-modified QCM sensor exhibited high repeatability, reversibility, and low humidity hysteresis.
Abstract reproduced from the published article under its CC BY 4.0 licence; copyright remains with the authors.
Related work.
- Most common sources of pollutants in GLAMs & Assessment of main challenges for an efficient IAQ control:Deliverable 4.1 2025
- Aptamer-molecularly imprinted polymer sensors for the detection of bacteria in water 2025
- Polymère à empreinte moléculaire pour la reconnaissance et l’immobilisation des bactéries photosynthétiques 2024
- MULTIPLEXED BIOSENSOR USING QUARTZ-ON-SILICON MICRO-ACOUSTIC (QSIM) TECHNOLOGY FOR IN-VITRO LABEL-FREE INVESTIGATION OF HEMOSTASIS 2023
- Luminescent polysaccharides thin films with potential bactericidal activity 2022
- An approach to compare performance of surgical masks for fighting against the COVID-19 pandemic 2022
New openQCM papers, by email.
A selection of new publications measured with openQCM, with software releases and application notes. A few emails a year.
Browse all papers.
Hundreds of peer-reviewed publications cite openQCM. Search full-text and filter by instrument, year, journal or topic.